BRH - Basic Roll Holder
Description
[Click here for the newer version 2 of BRH](https://www.thingiverse.com/thing:3731157) I tried the PHIL holder and had fitting/scaling issues so I ended up designing my own. The wheels should fit snug enough to stay together but loose enough to spin freely, sand prongs a bit if its too tight. The prongs should be strong enough to hold 1kg, anymore is unknown, I am working on a V2 with lower material usage/print time and higher strength on the prongs. ### This print requires - no bearings - no supports Print the panel with prongs facing up on bed, print wheels either flat side down; use large brim if worried about warping.  This took 10 hours per side at 30mm/s print speed & 40% infill, which can probably be reduced since I'm still somewhat new to 3d printing. ### settings - horizontal expansion = -0.04 (for my petg) may try -0.06/-0.08 for more loose spinning wheel - alternate extra wall = enabled (helps strength/adhesion on circular geometry) - zigzag infill/top/bottom check my profile for more extensive cura/marlin settings
Statistics
Likes
3
Downloads
0