Nerf Worker Talon Adapter - Fully Forward
Description
Update: Noticed some of the comments. Unfortunately, I plan on migrating off adapter-based blaster platforms and likely will not finish a solution for over-insertion, lack of flaring, and other issues. Talon mag adapter that sits fully forward and has a lever release. Warning: Not compatible with all magwells. You may need to use snips/flush cutters/file/etc. to cut down the front of the magwell. Warning: No prevention of over-insertion whatsoever. (When inserting Talon mag.) The top of the blaster's magwell needs to provide this. Warning: Magwell is not flared. Mag and magwell fits vary by blaster. May get you tagged in battle if not modified accordingly. Should be Compatible: Raider Requires Cutting: Stryfe, Sentinel Not Compatible: Caliburn, Hail Fire (duh) I will only be using this for the Raider/Rampage at first, but might try it in the Stryfe (and thus, support it) later. Marked as work-in-progress since I still didn't fine-tune the fit against the magwell itself, and the fit will vary depending on the blaster. Hardware: - Compression Spring: No particular size recommendation, but should be smaller than 5mm diameter and very roughly around 10-11mm long. You'll have to mess around and see what works, unfortunately. - 2x 4-40 x 3/8" Countersink Screws: Used to mount the insert. Superglue can also be used, but it's permanent! Print without supports. Includes one built-in model support gapped at 0.3mm above and below, to support the mag release notch in the body piece. No other supports are needed. Thanks to Worker, Captain Slug and Project-FDL for various bits of design inspiration.
Statistics
Likes
23
Downloads
0