Openbeam cableguides
Description
Cableguides designed to fit the Openbeam 15x15mm extrusions, without a nut in the slot. When printed in ABS with a 0.4mm nozzle these snap in to the slots. A M2 screw or two may be used to further lock them in place if needed. 5-0: Guide on the side. 5-1: Guide on top 5-2: Guide on top, with an offset of 4.5mm. Nice when having a plastic sheet as a separator of sorts laying on the side of the extrusion, like in my printer enclosure. (shown in a photo) No supports needed.
Statistics
Likes
5
Downloads
0