Monoprice Select Mini 60mm shroud
Description
I saw dual 30mm fans cooling the hot end and the print but I thought the stock method with one fan + ducted airflow to do both could do the same job with a larger fan. So I doubled the fan size and designed an adapter using nBurn's stock shroud model. This is a direct replacement for the existing shroud. You only need to unclip the old shroud and fan and clip in the new one. Then wire up the fan. This was designed for the V2 but it should work on the V1 but I have not confirmed this. Orientation worked best with the 60mm facing up and the 30mm side flush with the print bed. Took 7hrs. This could be reduced if you are in to tweaking the settings. I just used the fine print settings in CURA 4.0 If it turns out it's too much cooling I will add in a screen to divert more air to the part cooling an less to the hot end or vice versa.
Statistics
Likes
6
Downloads
0