Von Braun Ferry Rocket Stand
Description
This is a stand I made for the "Ferry" rocket designed by wernher von braun. Print four of these and set the rocket first stage canards into the slots in the stands. Size the stands up to 999.97% to fit the ferry rocket model on this site. I printed the stands with the wider part on the raft, but it may be beneficial to print them upside down from that orientation; I will leave that decision to you. However, if you do print them how I did, be very careful removing them from the raft; disconnect the parts touching the raft and then pull the part off of the supports (leaving the supports connected to the raft).
Statistics
Likes
10
Downloads
0