Snail fan e3dv6 hotend adapter
Description
Best hot-end cooling fan out there! SUPERB COOOLiNG !!! What is this good for u ask ??? 1 Better flow of material inside, specially low melting temp material like PLA not to get stuck inside hot-end throat !!! 2 No under-extrusions !!!! 3 No clogging !!! 4 Better print quality!!!!! Fan goes very tight inside ( maybe u will need to scrape some plastic whit knife off to get it inside tight, i printed it whit PETG witch is a bit flexible), add super glue just in case fan stays stuck and doesn't fall off !! This is less noisy than original 30mm fan, on picture tested whit s9+ 15cm away from it. Much better air flow ( tornado ). Cheers!
Statistics
Likes
3
Downloads
0