TBS Source One Foxeer Box 2 mount
Description
**Foxeer Box 2 mount for the TBS Source One frame.** There's a 25, 30 and 35 degrees version included. The camera is slide in through the back of the mount so you can't loose it in a crash unless the whole mount breaks off. The door on top of the Box can be opened while the camera is in the mount. It is kinda hard to open it so it wont open up in a crash very easy to protect the SD card from jumping out. The buttons on the side can be reached while the camera is in the mount so basicly there's no real need to get the camera out of the mount. I've printed it with the front of the camera mount flat on the bed and only 2 support towers on the tip of the 2 front feet. **Recommended versions** 25, 30 and 35 degree v3 is are stronger and wider so camera slides in easier but also gets pushed to the back of the case in crashes so the case comes in view of the camera 25 degree v5.1 30 and 35 degrees v5 are easier and cleaner to print around the power button and are reduced in weight comparing to the v3 versions and also have small bumpers in the back to prevent the camera sliding back in a crash. 25 degrees v5 has the same cut out for the power button as the v3 versions. See the change log below for more info. **Update 14-07-2019 12:20** Added 30 and 35 degrees angle **Update 6-8-2019** Added improved version of the 25 degree mount. It's 6 grams lighter than the previous version because I reduced the overall size and made the walls less thick. I've also added a bumper in the back to prevent the Box from sliding back in a crash and so the case comes in sight of the camera. Last but not least I reinforced the back screw holes because it sometimes cracked there on the previous design. I exclusively fly with 25 degree camera angle and I screwed up in Fusion360 with this version so I have to remake the whole design for 30 and 35 degree versions which I don't have time for. **Update 8-8-2019:** Added improved version of the 30 and 35 degrees mount. Made a slight adjustment for easier and cleaner printing results on the power button as well in this version. Also added v5.1 version of the 25 degrees mount with the easier printing adjustment as well. *If you like this Thing please consider clicking one of the affliate links below to support me.* Tevo Flash: http://bit.ly/2PGVo0w Foxeer Box 2: http://bit.ly/2jQaPbM Foxeer Box 2 ND filters: http://bit.ly/2jQaAxr ImmersionRC Tramp HV: http://bit.ly/2K41GIR Holybro Tekko32 35A: http://bit.ly/2KcRHjt
Statistics
Likes
5
Downloads
0