Z Motor Stand for RepRap Guru Prusa i3 V2
Description
File I made for the RepRapGuru Prusa i3 V2 to replace the four acrylic pieces that go next to the two Z motors. I didn't like how the motors were sort of "floating" and weren't on the ground. This made my printer lean forward at an angle. To solve this problem, I modeled the acrylic piece, and then extended it out and down so that it would touch the surface the printer is set on. The picture that I have uploaded of my print has the logo of my favorite college (Indiana University) on the side. I uploaded a version with and without the logo. From what I remember, they both take the same amount of time to print.
Statistics
Likes
3
Downloads
0