Raspberry Pi Camera Mount for MakerFarm Prusa i3v (OctoPrint)

Description

These Parts Allow You To Mount A Raspberry Pi Camera With Led Illumination On Your Makerfarm Prusa I3V To Observe The Bed Of The Printer. It'S Perfect For Use With Octoprint On A Raspberry Pi As A Network Printer Controller. The Bracket Mounts To The Left Bed Rail With Two M5 Screws, Washers And T-Nuts. My Kit Had Enough Extras. You Will Also Need An M3 Screw And Nut For The Finger Joint At The Top Of The Mast. The Camera Head Holds Two 1.5W Led Corn Lights, Available From Hobbyking For A Couple Of Dollars: Http://Www.Hobbyking.Com/Hobbyking/Store/Uh_Viewitem.Asp?Idproduct=26408&Aff=624762 In Addition To The Printed Parts, You Will Also Need A Piece Of Carbon Fiber Arrow Shaft. In The Us, You Can Get One At Wal-Mart For Less Than $4.

Statistics

Category

Tags