Big LED Arch
Description
Big LED Arch with only 3 different parts to print. No support needed, just use brim for the Arch. You need to print: - 14x Arch.stl, - 1x Base1.stl or Base1_touch.stl and - 1x Base2.stl. Each base have cutouts for 7 x M12 nuts (the Touch-Version 8x), to add weight (about 100g per side). It's not needed, but could add stability. To insert the nuts you must stop the print after 10.7mm layer! (M600 - Filament change) The switch hole on Base1 is 13x20mm (you can ad a support there, but is not needed). Matching switches: [2 way rocker On-Off](https://www.reichelt.de/wippschalter-1x-aus-schwarz-i-o-wippe-1801-2106-p154411.html), [3 way rocker On-Off-On](https://www.reichelt.de/wippschalter-1x-um-schwarz-i-o-ii-wippe-1808-1103-p108238.html) On the Arch there fits two 10mm LED Strips side by side with a length of 230cm. Size assembled: Width: 154cm Height: 81cm If you want to use the 3 way rocker: You can solder the + from stripe one to "I", the + from stripe two to "II", the power on the center of the switch and a diode (1n4007) between I and II. If switch position "I",one stripe lights up,and if switch position "II" both stripes lights up. Update: (30.08.2019) I add a Version with a Brightness Control - Touch Sensor Switch Module and a 5,5/2,1mm DC Mount.
Statistics
Likes
103
Downloads
0