Raspberry Pi 7 Inch Screen Minimal Rollbar Case - Easy Print - No Support
Description
7/26/2019: Final Version here --> https://www.thingiverse.com/thing:3771857 - Bigger handles, better access for cables, protection for Pi board, optional fan mount. This is a more minimalist version of my rollbar case for Raspberry Pi 7 inch touchscreen. Original Version --> http://www.thingiverse.com/thing:3752387 Everything about the original version remains essentially unchanged. It is literally just sectioned into thirds and the center section discarded. It takes about 6 hours to print (total for both parts). Prints best on the side, so that the handle lies flat. No supports needed. Not even any difficult bridging on this design. No problem with clearance around the screen's power ports. Kinda, this is the better version. I printed with 4 shells and 6 top layers and 0% infill. Printed on their sides, there's not even much top surface to close up with top layers.
Statistics
Likes
11
Downloads
0