Anycubic i3 Mega PSU cover for fan 100x15mm
Description
<b> Я не несу никакой ответственности, если вам не подойдет такой дизайн. </b> Это крышка блока питания для Anycubic i3 Mega, чтобы заменить стоковый кулер на вентилятор размером 100х15мм. <b> I do not carry any responsibility if the thing doesn't work for you. </b> This is a PSU cover for Anycubic i3 Mega to replace the default fan with a 100x15mm fan. It appeared to be a tight fit with a milimeter clearence from the induction coil. I added the corner support. The fan is mounted with the bundled screws. When I attached the fan to the fan socket it didn't work, than I discovered that is's controlled thought a thermistor. So to check I heated the board below the transformer with a hair dryer and it turned on. Also the stock M3 bolt of the printer lid is sticking out that the fan night touch it, so I put some shims under it. Overall I'm satisfied with the desight, though my fan is not that quite. I would say it is near 30% quiter than the default one.
Statistics
Likes
5
Downloads
0