Servo Cable Puller
Description
This is something I knocked up when I found that re-attaching the wing from my AR wing after transport was tricky to route the servo cable back into the main bay. The two pieces are designed to go at either end of a thin cable tie with one end becoming the handle and the other designed to fit over a servo plug (Dupont style, 3 pin). I would cover the servo end in heat-shrink to stop splitting in use and you will need a dap of CA glue to glue the end of the cable tie into place in it. I hope other pilots find a use for it - it's great when you need to pull a servo cable through a channel..
Statistics
Likes
25
Downloads
0