Simple shower box/stand support - 2020 Update
Description
A shower box/stand for different stuff found around the shower (shower gel, shampoo, liquid soap etc). It's made for a shower head support with a diameter of 25mm. If you have this diameter, this will stuck perfectly on it and will not sag. I've printed using PETG, no supports and 100% infill (I think it might work fine even with a lower infill - haven't tried). I've tested 0.2 and 0.3 mm layer height, and stick with the 0.3 mm layer height as there is no major difference between. (I have a 0.4 mm print head) 2020 update: it seems when there is a lot of steam or too much weight, the boxes start to slip. I've added a holder to put on top of the shower support and from there some links to connect it to each box/stand. The links it's best to be printed using 0.2 mm layer height as the tolerances are quite small. With the new links, the boxes support even a bigger weight :). - the links and top holder are printed using PLA.
Statistics
Likes
12
Downloads
0