Case for RasPi with two 8 Channel Relays
Description
<h1>Enclosure for RasPi 3 & 2 8 channel relays</h1> <p>Example: <a href="https://www.amazon.de/gp/product/B01M61VVGV/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1">Amazon: Elegoo 8 Channel Relay</a>.</p> Covered with 120mm fan for cooling down with low rpm, so noiseless. I used this case assembled under my Ikea Lack Table, with Repetier Server and CNCjs on an headless RasPi 3b+ to control three printer and one laser engraver. The two 8 channel relays controls moreover 2 white led stripes, 1 rgb light stripe, 2 exhaust fans, RasPi cooling fan, 3 printer and the laser engraver, charger for the 10" Tab - which i used to control the raspi. I didnt find so far, anything like this, so i made my own. I pay the most attention for assembling, so i decided to make it in 3 tiles. If i need an other chassis for a new raspi (change hardware relative often), so i dont must have a full case print I printed all with 10% infill, 20% would be a bit better. For assembling you need only four M5 screws and nuts, must check - think it was 45mm screws i used If you have questions, message in the comments
Statistics
Likes
6
Downloads
0