Bureau of Balance Bracer - The Adventure Zone
Description
A simple Bureau of Balance bracer I designed. Prints as a flat sheet, photos show it finished with filling and sanding primer, wet sanded, and Rustoleum 2x Metallic Silver spray paint. Use a heat gun or hair dryer to warm the unpainted side until flexible, wrap around your wrist, and run or spray water over it to make it hold the shape. The narrow end goes toward your hand. I like 40% infill, lower may show the infill pattern once bent, higher makes the shaping take longer. If your arm is large, you might want to put slots in the ends that you could feed lacing or elastic through, but I haven't found it necessary except with the largest of arms. Alternately, just print it larger so it's long enough to wrap around. Available for purchase here: https://www.etsy.com/listing/684511570/bureau-of-balance-bracer-rigid-3d-custom
Statistics
Likes
13
Downloads
0