Kress - Mafell compatible CNC Dust Shoe
Description
Here is my Dust shoe. before mine i only saw 2 dust shoes that relies on sucking air at the bit level and not 5-10cm away with a brush. it wroks perfectly (see videos https://www.youtube.com/watch?v=nLqacFkN3Pw and https://www.youtube.com/watch?v=iybi_flSjKE ) mine can open so you have clean access to the clamping nut for tool change. Thge dust shoe holder is simple and springy, this is by design as it helps you when opening the shoe for tool change. Also it helps fitting as the shoe is designed to fit on the little part of 43mm router ring that is out of the router holder. the shoe is put in place with the help of the vaccum tube weight and the tube holder that carn be rotated too. (you got much access if you rotate slightly to the right) use M5 bolt for the opening part, and use M3 screws to tighten the dust shoe to it's holder. use the weight of the vaccume tube to help fit. this one does not need any brush as you can see on the videos. I don't recommend PLA as it would not stand the heat of the routeur ring. use PETG or ABS. mafell is ok (tested on mine), waiting for confirmation about the kress holder.
Statistics
Likes
8
Downloads
0