HF3D Nebula (Wing extensions added)
Description
Update: Added a spar coupler part which can be used to make wing extensions, added photos and a video showing 25cm wing extensions added on each side to increase the wing span to 150cm Video:https://www.youtube.com/watch?v=OQrvO69onVs https://www.youtube.com/watch?v=SeePbo6RwHA First Hybrid Foam 3D Printed (HF3D) Airplane. Just add foam, glue and some carbon fiber spars! (Plus electronics). See summary of youtube videos for more technical specs https://youtu.be/-8wIVtBhyHA https://youtu.be/8XkEdBxdEAc <b>Need to print:</b> 4x wingRibHinge (These are the ribs with the attachment point for the aileron) 2x wingRib 4x aileronHinge 1x nose 1x wingMount (this is the center mount where the wing spars mount in) 1x wingToFuselageMount (This is the mount on the fuselage where the wingMount bolts on) 2x MotorMount (This motor mount fits the A2212 1000kv motor with the cross bracket you can find on amazon) <b>Spars:</b> 2x Square Rectangular Carbon Wing Tube 8x8x6.5x6.5x500mm 2x 3mm Round Carbon Fiber Wing Tube 3mmx1.5mmx500mm Space the motor mounts ideally over a rib segment, but make sure it is close to the fuselage, around 1-2 cm gap between the tip of the propeller and the fuselage. This is to decrease the torque in the case of an engine failure. I used a pair of cessna 182 replacement landing gear from hobbypark on amazon.
Statistics
Likes
24
Downloads
0