Mount and Controller Plate for DJI Crystalsky and Mavic 2 - V2
Description
Update: Aug 12, 2020 - After nearly a year of using this on and off (about 125 flights) I set my controller down on grass with the CrystalSky attached and the mount snapped apart. The CrystalSky mounting point itself was fine, it broke at the point where the neck strap hole is since there isn't much material between it and the outside walls. I'm going to work on a stronger design but if you use this mount please be cognizant of this and use at your own risk! -------------------------- I went back to the drawing board and created a new plate and mount for the Mavic 2 and Crystalsky. The biggest improvements are: the joining / rotating parts have teeth so lock in at various angles, the controller plate is more ergonomic and comfortable to hold, and the size of the joining parts are the same as for my Phantom 4 support arm so you only need to print the Crystalsky mount once and can use it on either controller. The controller plate sits snugly inside the handles, it should just fit inside the bottom rubber piece but not stick through the openings. You will need: 2 - 5mm x 15mm screws 1 - 5mm x 40mm screw 1 - 5mm nut
Statistics
Likes
11
Downloads
0