mini ar wing SMA holder
Description
this is a quick SMA holder i made as i do not need to go miles and miles, antennas are always best on the winds away from the motor(s) and other things that might interfere, but if you just want to try this out and fly, then this should be a good options, i printed it using PLA with supports and pushed it to where it was going to leave a make, then used a sharp object like a drill bit and made hold so that the feed would go in, once happy, and not forgetting to make a hole for the SMA wire, put some CP glue in each of the four holes, then install it, if you find this print helpful it would be nice to people to kindly TIP if you can if not then just enjoy anyways
Statistics
Likes
11
Downloads
0