Baseplate for the dualgear extruder for the Creality CR10 (S)
Description
There is no good baseplate for the dualgear extruder for the Creality CR10 (S). I made one including the filament sensor. The original lid of this filament sensor fits the one I designed. I have also added 2 wheels so that the filament goes straight into the extruder and does not sand anywhere and the filament sensor output is also directly opposite the extruder input. This is for wire feed from above, but also works with straight feed. The bearings that I used for the wheels are the same as in a V-wheel of the Creality CR10 (S). Update: Because I have added a support plate to increase the stability of the plate by fixing the plate to a v-wheel bolt, the pictures look slightly different than the stl file. The holes for securing the V-Wheels have been made larger so that an M3 bolt can pass. And with the upper wheel I made a recess at the rear where an M3 bolt nut be used.
Statistics
Likes
5
Downloads
0