Mighty Ban Hammer Modification
Description
This is a modification of the Mighty Ban Hammer by GAlden I altered the A-block and redesigned the handle grip from scratch, based on the original design. Instead of a printed shaft it now uses a 30mm dia. wooden shaft. It is designed to be printed twice as large as the original model, because it looks absolutely badass this way :D. Instructions: Print the handle_grip_modified.stl at 100% scale (It's pre scaled) Print the A_block_modified.stl at 200% scale Print the end_part_x_2.stl twice at 200% scale (get the file from the [original thing page](https://www.thingiverse.com/thing:2117399) and leave GAlden a like while you're over there ;) ) To glue the parts together I used UHU Allplast which works really good on PLA (not tested other filaments yet) and wood. The length of the shaft is up to your personal preference. Make sure the wood goes all the way to the bottom of the handle so it doesn't break of when you swing the hammer. If it's too tight just use some sanding paper on the wood. If you paint it I recommend to do it before you glue in the wooden shaft. Happy banning! :D
Statistics
Likes
9
Downloads
0