CR-X washer/spacer for Ender bed Silicons Buffer
Description
Unfortunately most silicon buffers are not high enough to provide a thigh fit for your CR-X print bed (in replacement of the springs). Therefore, if you like to use cheap Ender-2/3/... Silicon-buffers (Silikondämpfer) you need to extend the heights by 4mm. To replace the 3 spacer Creality is having below the springs I designed this thing. Just put my spacer underneath the buffers. The shape will support the nut hole which is not needed on CR-X https://www.ebay.de/sch/i.html?_odkw=4X+Silikonpuffer+Ender&_osacat=0&_from=R40&_nkw=4X+Silikonpuffer+Ender+3D Ensure to get the package where one buffer is slightly shorter than the others (3 x 18 mm & 1 x 16 mm - that is the one for the back-left corner)
Statistics
Likes
12
Downloads
0