Easiest CR-10 S/S4/S5 Z-Braces / M8 rods / strong print
Description
# This should be by far the easiest Z-rod upgrade for your printer. *Check out my construction video here:* https://www.instagram.com/p/B00FgQPo8bj/ *Be sure to follow me on insta:* @b03tz3D (instagram.com/b03tz3d) *Here is the download link for STEP files and such:* https://a360.co/2YtN8cA *Credit me if you do anything with it :)* The topbraces are a VERY PRECISE fit so be sure not to overextrude or you will need to do some sanding :) Everything prints *without supports!* Printing tips ---------------- I printed everything at 75% infill, except the screws, those were printed at 85%. But to be fair, if you print with 3 parameters you can easily get away with 50% infill or less (don't use less then 30%). It is a very strong mount! Printed ALL parts at 0.2mm Stuff you will need (not a lot!) ------------------------ The only things you will need are (which you cannot print): - 2x M8 rod (56cm or 22 inches) - 4x M3 screw / bolts For the M3 screws print these drop-in T-nuts: https://thingiverse.com/thing:3050607 Trust me, they are very strong and can easily handle this job! If you don't want to use them you can also use M4 with metal drop-in T-nuts if you want. Construction order: ------------------------- - Slide in top brackets - Screw the topscrews on the M8 rod - Screw the M8 rod into the bottom brackets (make sure it's snug and tight) - Slide the topscrews in their slots - Adjust / tension the whole setup (I made it so that it pulls on the frame)
Statistics
Likes
87
Downloads
0