HoverGames Drone RDDRONE-IOT Rapid-IOT hanger brackets
Description
HoverGames bracket for NXP Rapid-IOT board connected to RDDDRONE-IOT adapter board which attached to the HoverGames Drone mounting Rails. [Includes STEP file source format to allow editing] This is for the NXP HoverGames Drone KIT-HGDRONEK66 and RDDRONE-FMUK66 flight controller. It clips onto the 10mm diameter x 60mm spacing rails of the HoverGames drone The HoverGames drone uses an experimental flight controller (FMU) that runs PX4.io flight stack software, and others. It follows Dronecode.org connectorization standards. RDDRONE-FMUK66 (the FMU) includes two wire automotive Ethernet interfaces and dual CAN bus in addition to the traditional UARTs, SPI and I2C that is typical of PX4 (Pixhawk) type controllers. NXP Semiconductor is Linux Foundation Dronecode.org member Drone flight stack software is NuttX and PX4.io on the FMU. Video : https://www.youtube.com/watch?v=xLfMEuMjAZE Documentation : https://nxp.gitbook.io/HoverGames Website: https://www.hovergames.com Website: https://www.nxp.com/HoverGamesDrones
Statistics
Likes
1
Downloads
0