MantisX mount for Ruger MK III
Description
MantisX mount for the Ruger mark 3. During normal use the mount will work fine. But the mount will rotate if you bump the Mantis from the side with your hand or when putting it on a table. The mount only have one slot in the rail as this is not intended to be a generic picatinny. Print standing with support to get the strongest possible part. Use enough perimeters to get a solid part in the clip area. I have printed a few in generic PLA and they hold up well. The clip should give a firm grip if the printer is dialed in good.
Statistics
Likes
2
Downloads
0