Amsterdamman's 2mm lowered nozzle mount for Ormerod
Description
This Is My 2Mm Lowered Rermix Of The Ormerod1 Or Ormerod2 Nozzle Mount. Effectively Raising The Sensor 2Mm As Compared To The Nozzle. After A Few X-Carriage Collisions With Bridging Prints I Could Have Figured Out How To Improve The Print So The Bridge Was Even Better, But I Decided To First Make Collisions Much Less Likely Since The Print Was Still Good Enough For My Purposes. The Collision Is What Destroyed The Print. This Will Also Lower Your Z Height When The Sensor Reads Between 500-700 And I Now Use A Z Height Of 0.5 For My Home Point Which Is A Effective Sensor Height Of 2.5Mm Above The Bed. My Current Config.G Probe Height Is: G31 Z0.5 P570
Statistics
Likes
3
Downloads
0