Catan Tower Storage
Description
The Colonies edited to fit and covers https://www.thingiverse.com/thing:4693005 Explorer and Pirates Expac covers https://www.thingiverse.com/thing:4690042 traders and barbarian tiles for these interlocking bases https://www.thingiverse.com/thing:4679487 Seafarer Expansion covers https://www.thingiverse.com/thing:4670578 https://www.thingiverse.com/thing:4663644 santa cover https://www.thingiverse.com/thing:4653618 updated the handle because it was too short. oops! edit again added the bolts as a separate file for people having issues printing them alone. I suggest adding a raft. EDIT I modified this tower so the pieces fit better, no sanding needed. I also chopped it up so it's multiple pieces. :) I built a 3d catan board https://www.thingiverse.com/thing:2525047 but i didn't want to spend so much money on the magnets, so i used bases found here https://www.thingiverse.com/thing:3700300 However, very early into the process i realized i had no way to easily store them and found no options for these types of bases. So, using 3d builder, i created this tower for holding my pieces. This version is very snug, so I had to sand it down a bit to get it all to fit. I'm working on a new version that will make the sanding unnecessary, but it's still a WIP. I wanted a carry handle, but also wanted to use the center hole to hold a tower for my different robbers (it also fits the tube for catan numbers found here https://www.thingiverse.com/thing:2927739 which holds these numbers https://www.thingiverse.com/thing:2884108 or the basic cardboard ones) Handle design is from here https://www.thingiverse.com/thing:3628427 Handle is included with locking sides added. (print at 40% infill) I used https://www.thingiverse.com/thing:2486040 this latching system to snap the handle on. it is included separately and would need to be printed at 90% infill to be strong enough to hold it. I super glued it on the sides since it has to be printed in pieces to work. (and some might not want it at all) I also found that the pieces would hit the tops of the pieces and possibly damage them so i used these https://www.thingiverse.com/thing:2837866 storage covers, cut a spot out the puzzle piece so they could slide onto the tower easily and hold in place. (also included)
Statistics
Likes
39
Downloads
0