DJI M200 Yuneec Gimbal Mount
Description
I have a gimbal set up for a FLIR Vue Pro that I want to be able to mount on a DJI Matrice 210. I did a quick remix of the go pro mount from da429boss to add the correct tab that will slide into the Yuneec mount (see here: https://www.bhphotovideo.com/c/product/1223037-REG/yuneec_yuncgo3102_mount_set_for_cgo3.html). This slides into the mount until it stops. I tried to make a little bump at the end that would help keep it from sliding back off, but that was hard to print and then hard to install, so now it is just a friction fit, but it does seem like there is more than enough friction to stay on without any fear that the gimbal would slide off in flight. N.B. The actual part that slides in to the gimbal is quite thinly printed, but seems strong enough in the few PETG copies I made.
Statistics
Likes
2
Downloads
0