Cetus 3D frontpanel w. heatbed controller
Description
This is a frontpanel for the Cetus 3D printer. Update: the mountplate things On the back of the mountplate are some sunken holes (captive nut caves or so) not perfectly sized and not deep enough. Put in the nuts using the thermal method. Heat them up and push them into the plastic. Pls. The thing as a remote console - fighting the mess with the cable https://thingiverse-production-new.s3.amazonaws.com/assets/80/1d/9f/c8/3c/remote_console_fighting_the_mess.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/93/d1/47/87/67/mount_1.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/38/9c/03/3c/60/mount_3.JPG The pictures https://thingiverse-production-new.s3.amazonaws.com/assets/4e/48/9d/ad/36/heatbed_controller_case4.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/b5/96/08/25/e6/heatbed_controller_case3.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/ed/ea/a0/89/4f/heatbed_controller_case2.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/c3/2d/ea/3d/a2/heatbed_controller_case1.JPG It has the heated bed controller pcb and the driver boad inside. The parts: -the case with mounts for heated bed controller (TinyFabXY) controller pcb, holes for a switch ca 20x12mm, 2xLED ca 5mm -the mountplate with heated bed driver board (TinyFabXY) -cable strain relief clamp bar (print 2x) TODO: -The switch and LED's will be connected with the ports on the board inside the metal casing. -Probably the lock-sensor will show the state of the y-axis lock when engaged. -covers for screw holes on the frontside -foil with fancy symbols, to cover the scratchmarks the print received from the FR4 board used as printbed surface The small controller case https://www.thingiverse.com/thing:3812392 The lock https://www.thingiverse.com/thing:3811857
Statistics
Likes
3
Downloads
0