Snapmaker flexible filament adapter
Description
Made a remix of the snapmaker flexible filament adapter This one has a little tighter fit both around the pipe but also against the surrounding walls. I has also 2 groves for the tention wheel to come even closer to the extruder cogwheel. I printed it with HTPLA that resist 200 celsius after heat tretment. Printed it upside down with supports at 0.16mm layer height and 100% infill. Assembly notes (i take no responsibility of anything): - 1 Remove side panels and the two screws holding the cooling block - 2 Remove the nozzle and the upper pipe and pull out the cooling block - 3 Place the filament adapter with the thinker wall againt the cooling block and make sure it fits on the nozzle pipe - 4 Place the filament adapter and the tention wheel inside the case - 5 Press in the spring agains the cooling block and the case before pushing back the cooling block in the case - 6 Screw back the nozzle and back pipe as well as the outer walls Done! Recommended items needed: Patience, its a bit of a tricky assembly (see attatched images) Tip if you want updates or modifications
Statistics
Likes
33
Downloads
0