Ubiquiti AP to wallbox
Description
I had a ceiling mount electrical box not in use so I created this to bridge the gap between the mount holes in the box (3.281 inch screw distance) and the holes in the AP-AC-LR wall mount. I'm not sure if other Ubiquiti APs use the same screw patterns or not. The small holes for the AP mount are meant to be used with the drywall screws but now they just thread in to the plastic so no nuts are needed on the back side, which is hard to get to. Use regular wall box screws for that connection. Printed in ABS because I heard the top of the AP can get a bit hot and over time PLA might warp.
Statistics
Likes
11
Downloads
0