Spool Stand
Description
My spool stand from Anycubic anfortunetly broke, so I decided to make my own with ball bearing. This spool holder is preatty small so should easy to print it on many printers. All you need is "608" ball bearings, for some parts You will need to use some force to attach them, like the "Connection". Bearing caps will need extra care to fit in them, I reccomend to sand them a little bit. Spool Diameter Maximum diameter: <124mm Maximum hole diameter: <50mm Maximum width: <100mm(depends on the hole diameter) Stand Dimentions without Spool length: 180mm width: 170mm height: 190mm
Statistics
Likes
10
Downloads
0