M12 Lens Extension
Description
Had a problem mounting some lenses on Raspberry Pi derivative cameras, especially the shorter M12 mounts so remixed this as a short extension. Printed using a 0.6 nozzle which worked well with V1.6 but might be better with a 0.4 nozzle or smaller. 0.06 layers, but it might be OK at 0.10 layers. <b>Print 2 or one other item at the same time to help cooling is it prints</b> Clean up bed edge to ensure thread has clear start. Make sure any cleaning up is fully cleared away before inserting onto camera body, probably a good idea to try fitting a lens and check the thread thoroughly before fitting to the camera body too!!
Statistics
Likes
10
Downloads
0