Sakura D4 Front Lower Control Arm

Sakura D4 Front Lower Control Arm

Description

Sakura D4 front lower control arm. Created this for better clearance and to use readily available end links since I kept braking mine. Depending on your printer quality, the fit might be a bit tight. This was designed intentionally, a little sanding or clean-up with a drill should make everything slide right in. End links I used are Traxxas 5525. Assembly; I reused as much factory pieces as I could, so all the obvious bits minus the end links should swap right over. To secure the end link, you can either drill a small hole through the arm and link once assembled and angles all set up and run a small screw, or you can use your standard super glue. Both have worked well enough.

Statistics

Likes

8

Downloads

0

Category

R/C Vehicles