Sterilite 20Qt (19L) Drybox
Description
This is the simplest and quickest to print dry box I can imagine. It holds 3 spools. You need only the following: - Superglue - Two prints of (SteriliteHolder.stl) - One Sterilite 20Qt (19L) gasket box available everywhere! [target](https://www.target.com/p/sterilite-20-qt-gasket-box-clear-with-blue-latches/-/A-15066036), [amazon](https://www.amazon.com/Sterilite-19324306-Gasket-Aquarium-Latches/dp/B00H1PS2TS), [walmart](https://www.walmart.com/ip/Sterilite-20-Quart-Gasket-Box-with-Clear-Base-and-Lid-6-Pack-19324306/633637534), etc - 1/4 inch or 6mm rod. 14 inches or 35 cm length [homedepot](https://www.homedepot.com/p/Everbilt-1-4-in-x-48-in-Plain-Steel-Round-Rod-801587/204273972), [amazon](https://www.amazon.com/Brass-Round-Favordrory-Diameter-Length/dp/B07H1FC42W/) optional: - Some kind of push fit connector and tube [amazon](https://www.amazon.com/SIQUK-Fittings-Straight-Pneumatic-Connector/dp/B07FPJHRTQ) - Desiccant Assembly instructions. - Apply glue to your printed parts and stick them to either end of the box. Keep them in place with a piece of tape while the glue dries. It's important they are roughly level and upright - Measure your rod and cut it to length with a hacksaw or whatever means you need. - Done - Optionally drill a hole through the box and screw in your push fit connector. (PushFitNut.stl)
Statistics
Likes
14
Downloads
0