Sigma ROX 6.0 Chip for garmin mount
Description
Adapter to fit a Sigma ROX 6.0 bike computer to a Garmin mount. This adapter is 1/4 turn to lock in, not 1/8 turn like the original Sigma Twist Lock. Part is optimized to print upright like shown in the files. A bit of bridging is needed within the twist lock segment. Parts needed: 2x M3 screws for contact 2x M3 screws for mounting in the garmin mount 1x small wire (max 1mm diameter) about 2cm long IMPORTANT: To get the Sigma bike computer to search for sensors a connection between the metal contacts needs to be made. Therefore a conductive wire needs to be embedded into the channel between the two holes on the top side. I have done this by stopping the print when the channels is nearly finished up und stuffed the wire in there. When finished the two holes get filled with two M3 screws to make contact with the computer. .step files included for customizing further.
Statistics
Likes
0
Downloads
0