DualDrive & V6 direct drive mount for Tronxy X5S with the SBase firmware
Description
This DualDrive Extruder is mounted as direct drive with V6 hotend. The Tronxy X5S' original metal X carriage is kept to ensure the ridged hotend installation. Though, need to drill 6mm hole for the stepper axle if direct drive installation is used. For the extruder 22mm 'pancake' nima17 stepper is reuired The unit is made for 4020 radial blower to ensure equal 360-cooling. Many parts has insulation wall to aid printing ABS with open printer. ABS or other stiff higher temperature filament.Also raft is recommended to avoid warping.(To print with-out the walls reduce printable wall width below 0.39mm) This set-up will move the hotend nozzle 15mm forward so the bed should be moved that much in -Y direction to keep 330 printing area. On the other one hand the nozzle runs 15mm higher so ZMax can be set as 415mm get bit higher maximum print size. Update: Fan shroud is now 1mm thinner & streamlined Add-on, getting the full printing space: Moving the board is a quite easy job. Here's the drilling jig for the job. Put the Z-rail screw on the other end, place the jig on the existing hole and drill 4mm holes on the front of the current holes. Also the bed wire holder needs to be a bit longer and notice https://www.thingiverse.com/thing:3951448 Added the Marlin 2.0.0 config-files for MKS Sbase but also 'firmware.bin' if you're not fancy to compile it by yourself. Place firmware.bin to the microSD card and restart the printer.
Statistics
Likes
14
Downloads
0