Specna Hopup Arm - Original and Flat
Description
A fairly exact copy of the hop-up arm used in the original Specna Arms Edge SA-E17, but most likely the same one is used in any Specna replica with a rotary hopup chamber. There are two versions: the copy of the original part, and a sewed-off version for R-hop and similar. Use a 2.0 drill bit to clear the hole and optionally some sand-paper to give a final touch. Print in ABS. Do *not* use PET or PET-G because it bends, and also avoid PLA since it will melt on the first hot day.
Statistics
Likes
5
Downloads
0