Powerade Gnat Catcher
Description
I HATE GNATS! This summer I seemed to have been overrun by gnats. After a very disgusting event when I breathed one of the lil' b*stards down my throat I flew off into a killing rage! This build is the direct result of those murderous feelings... The screw cap was designed to fit on a 32 oz Powerade bottle but it should also fit on a similarly sized Gatorade bottle. I printed everything using a .2mm layer height. No need for precision here! If you get any stringers across the small opening, just use a little drill bit, a paper clip, or some other small, pointy object to clear the hole. This prints without any supports, but you might need to rotate the model so the cap is next to the build plate. Bait your trap with 1/2" of orange juice, wine, old fruit, or just about anything. Those nasty buggers don't seem to be too picky. Have fun killing gnats!
Statistics
Likes
19
Downloads
0