Creality Ender 5 Pi Camera Mounting System (Sorry about distorted pics)
Description
Sorry if the pictures look skewed. This is a mounting system for a Pi camera on the Ender 5. These can be mounted in any of the corners or on the front or rear cross bar. The piece the camera fits into has an internal slot that the ribbon cable goes through, make sure you don't leave the cable on the outside. When decide which spot you want to mount on, choose the appropriate piece (triangle goes in the corner, the other slotted piece is for mounting on the front or rear top crossbar), slide the camera holder into the slot, then run ribbon cable through, connect to the camera and slide camera into slot. You will need to reboot Octoprint for the camera to be recognized. There could be some difference in tolerances in these Chinese-made parts (both the camera and Ender crossbars) so you may need to do some post-processing/sanding to get a good fit in the spot you want.
Statistics
Likes
40
Downloads
0