Crealitly Extruder No Friction Mod, Full Replacement. Possible Layer Skipping Fix!
Description
<h1>It can be a fix for Layer skipping!!!</h1> <h2>Since I use this extruder i don't have any layer skipping anymore! it's not guaranteed but it can help to prevent layer skipping.</h2> I don't exactly know how much creality printers have the same extruder as my Cr-10s check it first bevore you want to use it. This can be a complete replacement for your old Extruder, i designed this to have the least amount of friction with the filament. Every hole is big enough for a Teflon or Capricorn tube. I made two versions, one normal Extruder and one where you can connect a filament sensor on it (Cr-10s sensor) you only need one M4 Nut for the "Exturder Part 2" Edit 09.09.2019 its probably better if you use the original extruder "arm" instead of "extruder part 2" the part who holds the filament in line is deforming itself after some time (I printed it in PLA with 30% infill) just ged a 4mm drill and SLOWLY drill into the hole from the original extruder arm where the filament goes through but stop 1mm before you reach the other end now with the 4mm hole you can insert a piece of Teflon or Capricorn tube. you still have the same effect and less friction with the filament. I just didn't wanted to do this first because I didn't wanted to damage the original parts but after I had a bit of trouble with this bearing bending silgthy to the side (it made it harder for the extruder to ged grip on the filament) I considered that it is better to make this small improvement on the original part. (Sorry for my bad English) [Donate if you want, need more Filament for other Projects/Prototypes ;)](https://www.paypal.me/StriK3FoRC3Creator)
Statistics
Likes
8
Downloads
0