Spooderbox. Small creature enclosure.
Description
 ___________________________________ Spooderbox ============================== Small Animal Enclosure. ----------------------------------- ______________________________________________ [](https://discord.gg/nHr7RV5) __________________________________________ [](http://bit.ly/2LMBt19) [Polish shop here.](http://bit.ly/2Xu2uIA) __________________________________________ [](https://www.facebook.com/3DPrintSlav) ____________________________________ [](https://paypal.me/BlackHideki) ______________________________________________________________ Quite simple and modernistic animal enclosure, requres 3 glass panes (one extra optional), some silicone, and a small animal. Needed Parts: - 3 glass panes the size of 154x154 (+-1mm) and max thickness of 4mm (3.5 max recomended). - Aquarium/Food grade silicone - Optionally a 135x50mm glass pane. Instruction: - Print all parts. Depending if you want windowed hatch or windowless one print a proper version. When needed print with supports from buildplate only. - Print a Spooderbox vent with no top and bottom layers, dense infill, and 4+ walls. Infill structure will act as a vent holes, make sure they are small enought to not let your animal escape. - Slide into a base and glue using a silicone 2 side glass panels. Slide front panel in but do not apply silicone there, its design to as as a entry point that you can slide in and out at will. - Glue vent to a Spooderbox top using silicone or other glue. - Use silicone to glue Spooderbox top to a base, remember to not glue fron glass panel to anything and make sure you can slide it in/out. - Optionally glue smaller glass pane to a hatch, or use windowless hatch. - When all silicone sets fill enclosure with decour of your choice, and let your animal in, slide front panel in and close everything using top hatch. Cubone skull I used as a decour can be found here: https://www.thingiverse.com/thing:2839481 I sized it down to around 5 cm.
Statistics
Likes
70
Downloads
0