Large 2 manual color Punisher Medal
Description
Made a medal for my brother as part of his action figure collection. Punisher model comes from somewhere on the internet as part of another design which I cut up in Fusion 360. The logo itself was re-meshed and resized, decreased faces and leveled out. The medal part i then model in F360, including indents for 3 x 6mm x 3mm neodymium magnets and 4x finger grab spots to remove the medal from a surface once attached. I super glued (ca glue) the magnets in place Obviously any metal surface can be used for the display or alternatively to wall mount, while model is on its face (magnets up), take a piece of paper and index the magnet locations, transfer the marks to a wall and drill three screws that match the points, check screws are magnetic before hand
Statistics
Likes
3
Downloads
0