Lenovo M73 Tiny (USFF) VESA 75x75 & 100x100 Monitor/Wall Mount
Description
UPDATE: I printed this vertically in 8.5 hours, accellerated printing. It comes out awesome with no supports. I highly recommend Prusa Slicer + vertical print. This THING was designed from scratch. I modeled it from my Lenovo M73 PC after seeing the commercial mount for $ 40+ shipping on ebay. I tested multiple times, it should work very well for you. I hope you enjoy it. My final test print is printing as I post this. (4th revision). It uses a lot of filament & time so double-check settings and don't accelerate speeds too much and ruin it (knocking down tree supports) If printing flat, the support material is terrible to remove and will leave a rough edge on the underside of the lip. (sorry, I tried to resolve this and with no luck) Print vertically as shown in picture to avoid the need for supports. It will take a very long time but should be worth it in the end. Cura: (for Tree Supports if not Vertical) Prusa Slicer 2.0 for flat print recommended) - Print Flat (on bottom) as pictured - Tree Supports Enabled - 30-35 % Infill - 3-4 Bottom/Top Layers - 4 Vertical Shells/Walls - 0.20 or better resolution UPDATE: Pictures of actual mount in black are the results from Cura w/Tree supports @ 150% print speed (cura defaults) for Ender 3. The tree supports by far are superior to Prusa Slicer 2.0 (no tree support feature). 11+ hours to print.
Statistics
Likes
22
Downloads
0