Raspberry PI support for 1" PVC pipe
Description
This is a support for 1" PVC pipe, in my case, this is for a custom hydroponic system, the holes in the design are made for 6mm (M6) diameter screws, and 20mm large (I recommend 30mm). The pipes are not very accurate with the measurements so in my pipe it keeps a bit loose, but nothing that can't be solved with a bit of paper as showed in the picture, I'll try to figure out how to fix it in my next design. Also, I suggest M6 butterfly nuts for the screws. The screws for the RPI are M2.5 (not so common), also small support is required. I had support drawn in a early design, however is more difficult to get a proper M2.5 large screw for that, so I remove it, reducing the complexity of the model. Here a suggested Amazon list to get this project well done: https://www.amazon.com/gp/product/B07F14J7X8 https://www.amazon.com/gp/product/B075K3QBMX https://www.amazon.com/gp/product/B07H1CGT69 https://www.amazon.com/M6-1-0-Flanged-Flange-Hexagon-Stainless/dp/B07Q3NF8M6
Statistics
Likes
11
Downloads
0