Raspberry pi 3 b+ gopro mount case
Description
This is a remix of a case I found on an external site. I added an enclosure and mounting pins for the camera and also a slot for the ribbon cable, and then added a gopro mount for the base. I eventually intended to add a cover for the camera, and the enclosure is slotted for it, but I never got around to it since the friction fitting of the pegs keeps the camera in the enclosure, and I am too lazy to make the cover. This design is just a dirty quick replacement that I needed to fill the void of a gopro case I had for the pi zero, since no gopro cases for the pi 3 seemed to exist. Hope its of use to you. ***Note, if you use this mount orientated in the same direction as shown in my pictures, you will need to flip the camera image in your desired software, so it's not upside down. I am using mine for octoprint, and octoprint has that parameter available in its settings. Original design I used for the remix is here https://grabcad.com/library/raspberry-pi-case-model-b-2-3-1
Statistics
Likes
1
Downloads
0