E3DV6 Part Cooling 4020 Blower Fan Assembly
Description
Part cooling fan for to suit E3DV6 and my Tevo Tarantula. Can be used with the carriage that i have designed for an E3dV6 hotend or with a E3DV6 hotend that’s not on a Tevo . I bought a Chinese Clone hot end and the heat sink fan was RUBBISH. I was forever getting little mushrooms in my filament and blockages when using PETG or PLA filaments. This has solved my problem and will more then likely solve yours too! I have incorporated the same 4020 Blower fan that I used to use for part cooling into this Hot end cooling/Part cooling duct assembly. There is a version specifically for the carriage i have designed, it has 2 bolt holes and the E3DV6 outer clamp integrated into it, the other just clips over the heat sink of a E3DV6. Print it in ABS or PETG just to be safe, it stays far enough away from the heater block that PLA would probably be alright but i would recommend erring on the side of caution. Happy Printing!!
Statistics
Likes
0
Downloads
0