Card Box for Hand and Foot
Description
**NOTE: This is an incomplete work-in-progress (WIP). Expect more content as development progresses.** This project is a box to hold multiple decks of playing cards for the game of Hand and Foot. Typically, Hand and Foot calls for one more deck than players. This version of the box holds seven decks or enough cards for 6 players. I haven't attempted to print it yet mainly because my Ender 3 hasn't arrived yet. Then there's assembly, probably a few calbration and test prints, and a couple of mod prints to do before this one is queued. The STL for the whole box only exists to get Thingiverse to add a thumbnail for the overview. Trying to print it would likely be a disaster. **Updates** 20 Sep 19 - The previous version of the box wasn't long enough for 7 decks. It also was 5 mm thick which is quite a bit. The current version reduces the wall thickness to 3.3 mm. It still has a 0.3 mm relief. The thinner walls dictated filets where the bottom and lid overlap to keep the corners from getting too thin. I also added a pattern of holes. The idea was to reduce the amount of material, which it did, if only slightly. I liked the look so I kept them.
Statistics
Likes
4
Downloads
0