40mm Fan support for E3D V6
Description
40mm fan support fot E3D V6 *----VERSION 1.1----* Updated version after the v1.0, smaller, infill always 30%, closer to the heatsink giving you stable air flux. *----VERSION 1.0----* Be careful that the fan is always pushing out the heat. In case the fan is not fully working the PLA might get too hot and the support can melt. I also reccomend using a 12V 40mm connected directly to the PSU so you will get full performance I will update the changelog in future trying other design, this is the first and works well in my situation. Hope you will be fine too
Statistics
Likes
0
Downloads
0